Viewing A List Of Egress Interfaces; Adding An Egress Interface - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Section 5.29.9.1

Viewing a List of Egress Interfaces

To view a list of egress interfaces configured for a generic tunnel, navigate to tunnel » l2tunneld » generic »
{name} » remote-daemon » egress-if, where {name} is the name of the generic tunnel. If egress interfaces
have been configured, the Generic L2 Tunnel Egress Interface table appears.
Figure 776: Generic L2 Tunnel Egress Interface Table
If no egress interfaces have been configured, add interfaces as needed. For more information, refer to
Section 5.29.9.2, "Adding an Egress
Section 5.29.9.2

Adding an Egress Interface

To add an egress interface for a generic tunnel, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to tunnel » l2tunneld » generic » {name} » remote-daemon » egress-if, where {name} is the
name of the generic tunnel.
3. Click <Add egress-if>. The Key Settings form appears.
Figure 777: Key Settings Form
1. Egress Interface Box
4. Configure the following parameter(s) as required:
Parameter
egress-if
5. Click Add to add the egress interface.
Viewing a List of Egress Interfaces
Interface".
1
2. Add Button
Description
The egress interface for Ethernet type frames.
Chapter 5
Setup and Configuration
2
659