Siemens RX1500 User Manual page 579

RUGGEDCOM ROX II
User Guide
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » static » ipv4 » {subnet} » dev, where subnet is the subnet (network/prefix) of the
static route.
Click <Add dev>. The Key Settings form appears.
3.
Figure 636: Key Settings Form
1. Interface Name Box
4. Configure the following parameter(s) as required:
Parameter
Interface Name
5. Click Add to add the interface. The Static Route Using Interface form appears.
Figure 637: Static Route Using Interface Form
1. Distance Box
6. Configure the following parameter(s) as required:
Parameter
Distance (optional)
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Adding an Interface for an IPv4 Static Route
1
2. Add Button
Description
The interface for the static route.
1
Description
The distance for the static route.
Chapter 5
Setup and Configuration
2
547