Deleting A Static Route - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 626: Key Settings Form
1. Subnet (Network/Prefix) Box
3. Configure the following parameter(s) as required:
Parameter
Subnet (network/prefix)
4. Click Add to add the route.
5. If necessary, configure either a gateway or an interface for the static route. Only one can be configured per
static route. For more informatoin, refer to
Section 5.22.7.1, "Configuring Interfaces for IPv6 Static
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
Section 5.22.4

Deleting a Static Route

To delete a static route, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to routing » static » {protocol}, where {protocol} is either IPv4 or IPv6. The Static Route table
2.
appears.
540
1
2. Add Button
Description
The subnet (network/mask) of the static route.
Section 5.22.6.1, "Configuring Gateways for IPv6 Static Routes"
Routes".
RUGGEDCOM ROX II
User Guide
2
or
Deleting a Static Route