Siemens RX1500 User Manual page 687

RUGGEDCOM ROX II
User Guide
Figure 770: Key Settings Form
1. Name Box 2. Add Button
3. Configure the following parameter(s) as required:
Parameter
name
4. Click Add to create the tunnel. The Generic L2 Tunnel Protocol form appears.
Figure 771: Generic L2 Tunnel Protocol Form
1. Ingress-If List
5. Configure the following parameter(s) as required:
Parameter
ingress-if
replace-mac
6. If necessary, configure one or more remote daemon IP addresses for the tunnel. For more information, refer
to Section 5.29.8.2, "Adding an IP
7. If necessary, define one or more ethernet types to be forwarded. For more information, refer to
Section 5.29.10.2, "Adding an Ethernet
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
8.
to proceed.
Click Exit Transaction or continue making changes.
9.
Adding a Generic Tunnel
1
Description
A description of the generic tunnel.
1
2
2. Replace-mac Check Box
Description
The interface to listen on for Ethernet type frames.
Replaces the sender's MAC with the out-interface's MAC.
Address".
Type".
Chapter 5
Setup and Configuration
2
655