Deleting An Interface For An Ipv4 Static Route; Managing Static Multicast Routing; Enabling/Disabling Static Multicast Routing - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Section 5.22.7.4

Deleting an Interface for an IPv4 Static Route

To delete an interface for an IPv4 static route, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to routing » static » ipv4 » {subnet} » dev, where subnet is the subnet (network/prefix) of the
static route. The Static Route Using Interface table appears.
1
Figure 638: Static Route Using Interface Table
1. Add Button 2. Edit Button
Click Delete next to the chosen interface.
3.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.23

Managing Static Multicast Routing

The following sections describe how to configure and manage static multicast routing:
• Section 5.23.1, "Enabling/Disabling Static Multicast Routing"
• Section 5.23.2, "Managing Static Multicast Groups"
• Section 5.23.3, "Managing Out-Interfaces"
Section 5.23.1

Enabling/Disabling Static Multicast Routing

To enable or disable static multicast routing, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to routing » multicast » static. The Static Multicast Routing Configuration form appears.
2.
548
2 3
3. Delete Button
Deleting an Interface for an IPv4 Static Route
RUGGEDCOM ROX II
User Guide