Deleting A Vlan Id For A T1/E1 Line - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
1
Figure 863: VLANs Table
1. Add Button 2. Edit Button
3. Click Delete next to the chosen VLAN ID.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.35.8.6

Deleting a VLAN ID for a T1/E1 Line

To delete a VLAN ID (VID) configured for either a T1 or E1 line, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to interface » wan » {interface} » {protocol} » channel » {number} » connection » hdlc-eth »
2.
vlan, where {interface} is the WAN interface, {protocol} is either T1 or E1, and {number} is the channel
number. The Ethernet Over HDLC VLAN Settings table appears.
1
Figure 864: Ethernet Over HDLC VLAN Settings Table
1. Add Button 2. Edit Button
3. Click Delete next to the chosen VLAN ID.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
Click Exit Transaction or continue making changes.
5.
748
2 3
3. Delete Button
2 3
3. Delete Button
RUGGEDCOM ROX II
User Guide
Deleting a VLAN ID for a T1/E1 Line