Deleting An Lsp Generation Interval - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
4. Click Add to create the new interval. The LSP Generic Interval Routing Type form appears.
Figure 461: LSP Generic Interval Routing Type Form
1. Interval Box
5. Configure the following parameter(s) as required:
Parameter
Interval
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
6.
to proceed.
Click Exit Transaction or continue making changes.
7.
Section 5.18.6.3

Deleting an LSP Generation Interval

To delete an LSP generation interval for an IS-IS area, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » isis » area » {name} » lsp-gen-interval, where {name} is the unique
name for a routing process that belongs to a specific router. The LSP Generic Interval Routing Type table
appears.
1
Figure 462: LSP Generic Interval Routing Type
1. Add Button 2. Edit Button
422
Description
The IS type for this setting, specified as level-1-only, level-2-only or level-1-2.
1
Description
Minimum interval in seconds, ranging from 1 to 120. Default is 30.
2 3
3. Delete Button
RUGGEDCOM ROX II
User Guide
Deleting an LSP Generation Interval