Adding A Network Ip Address; Deleting A Network Ip Address - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 553: Subnet Table
If no IP addresses have been configured, add addresses as needed. For more information, refer to
Section 5.20.5.2, "Adding a Network IP
Section 5.20.5.2

Adding a Network IP Address

To add an IP address for a RIP network, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to routing » dynamic » rip » network » ip and click <Add ip>. The Key Settings form appears.
2.
Figure 554: Key Settings Form
1. Subnet Address/Prefix Box
3. Configure the following parameter(s) as required:
Parameter
Subnet Address/Prefix
4. Click Add to add the IP address.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
5.
to proceed.
Click Exit Transaction or continue making changes.
6.
Section 5.20.5.3

Deleting a Network IP Address

To delete an IP address from a RIP network, do the following:
488
Address".
1
2. Add Button
Description
The IPv4 network address and prefix.
RUGGEDCOM ROX II
User Guide
2
Adding a Network IP Address