RUGGEDCOM ROX II
User Guide
Figure 246: Trigger Action Form
1. Perform Button
2.
On the Set Maint Password form, configure the following parameters:
Parameter
new-password
new-password-repeat
old-password
On the Trigger Action form, click Perform.
3.
Section 4.10.5
Resetting Passwords and Passphrases
If either the admin, boot or maintenance password/passphrase is lost, the only method for resetting the
password/passphrase is to physically connect to the device and reset the password/passphrase through the
Command Line Interface (CLI). For information about resetting passwords/passphrases, refer to the ROX II v2.6
CLI User Guide for the RX1500 device.
Section 4.11
Scheduling Jobs
The ROX II scheduler allows users to create jobs that execute command line interface (CLI) commands at a
specific date and time, or in response to specific configuration changes. Typical applications include scheduling
the regular clearing of system logs, or performing periodic file transfers to remote servers.
There are two types of scheduled jobs:
• Periodic jobs are executed at a specified date and time.
• Config change jobs are executed only when a specific.
The following sections describe how to configure and manage scheduled jobs:
•
Section 4.11.1, "Viewing a List of Scheduled Jobs"
Resetting Passwords and Passphrases
Description
The new password or passphrase. Make sure the password/passphrase complies with
the password complexity rules configured for this device.
The new password or passphrase. Make sure the password/passphrase complies with
the password complexity rules configured for this device.
Specify the old password.
Chapter 4
System Administration
1
231