Chapter 3
Device Management
Parameter
runs
calibration
4.
Read and follow the instructions on the Start Cable Diagnostics Test.
5.
Click Perform to start the test. For information about how to view the test results, refer to
"Viewing Cable Diagnostic
Section 3.18.8.2
Viewing Cable Diagnostic Statistics
To view the statistics collected for a switched Ethernet port after a cable diagnostic test, navigate to interfaces »
switch » {slot/port} » diagnostics, where {slot/port} is the slot name and port number of the switched Ethernet
port. The Cable Diagnostic Results form appears.
Figure 107: Cable Diagnostic Results Form
1. Running Check Box
Count
9. Failure Count
This form provides the following information:
106
Description
Default: 10
Default: 0.0
Statistics".
1
2
3
4
5
6
7
8
9
2. Good Termination
3. Open
4. Short
5. Impedance Mismatch
RUGGEDCOM ROX II
Section 3.18.8.2,
6. PassFailTotal
7. Run Count
Viewing Cable Diagnostic Statistics
User Guide
8. Pass