Adding An Hdlc-Eth Vlan - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Figure 849: Ethernet Over HDLC VLAN Settings Table
If no VLANs have been configured, add VLANs as needed. For more information, refer to
"Adding an HDLC-ETH
Section 5.35.6.2

Adding an HDLC-ETH VLAN

To add a VLAN to an HDLC-ETH connection, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to interface » wan » {interface} » {protocol} » channel » {number} » connection » hdlc-eth »
vlan, where {interface} is the WAN interface, {protocol} is either T1 or E1, and {number} is the channel
number.
3. Click <Add vlan>. The Key Settings form appears.
Figure 850: Key Settings Form
1. VID Box 2. Add Button
4. Configure the following parameter(s) as required:
Parameter
vid
5. Click Add to create the new channel. The Ethernet Over HDLC VLAN Settings form appears.
Adding an HDLC-ETH VLAN
VLAN".
1
Description
VLAN ID for this routable logical interface
Chapter 5
Setup and Configuration
Section 5.35.6.2,
2
739