Configuring Certificates And Keys - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Navigate to tunnel » ipsec. The IPsec and Syslog forms appear.
2.
Figure 717: IPsec Form
1. Enable IPsec Check Box
3. Configure the following parameter(s) as required:
Parameter
Enable IPSec
NAT Traversal
Keep Alive
4. Configure one or more pre-shared keys. For more information, refer to
Shared Key".
5. Configure one or more encrypted connections. For more information, refer to
Connection".
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
6.
to proceed.
Click Exit Transaction or continue making changes.
7.
Section 5.28.3

Configuring Certificates and Keys

To configure certificates and keys for IPsec Tunnels, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Add a CA certificate and Certificate Revocation List (CRL). For more information, refer to
"Adding a CA Certificate and CRL"
3. Add a private key. For more information, refer to
4. Add a certificate. For more information, refer to
5. Add a public key. For more information, refer to
616
1
2
3
2. NAT Traversal Check Box
Description
Enables IPsec.
Enables NAT Traversal.
The delay (in seconds) for sending keepalive packets to prevent a NAT router from
closing its port when there is not enough traffic on the IPsec connection.
3. Keep Alive Box
Section 5.28.5.2, "Adding a Pre-
Section 4.7.2.2, "Adding a Private
Section 4.7.4.3, "Adding a
Section 4.7.3.2, "Adding a Public
RUGGEDCOM ROX II
Section 5.28.6.2, "Adding a
Section 4.7.1.3,
Key".
Certificate".
Key".
Configuring Certificates and Keys
User Guide