Viewing A List Of Gateways For Ipv4 Static Routes; Adding A Gateway For An Ipv4 Static Route - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Parameter
Distance (optional)
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.22.6.2

Viewing a List of Gateways for IPv4 Static Routes

To view a list of gateway addresses assigned to an IPv4 static route, navigate to routing » static » ipv4 »
{subnet} » via, where subnet is the subnet (network/prefix) of the static route. If addresses have been
configured, the Static Route Using Gateway table appears.
Figure 630: Static Route Using Gateway Table
If no gateway addresses have been configured, add addresses as needed. For more information, refer to
Section 5.22.6.3, "Adding a Gateway for an IPv4 Static
Section 5.22.6.3

Adding a Gateway for an IPv4 Static Route

To add a gateway address for an IPv4 static route, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » static » ipv4 » {subnet} » via, where subnet is the subnet (network/prefix) of the
static route.
3. Click <Add via>. The Key Settings form appears.
Viewing a List of Gateways for IPv4 Static Routes
Description
The distance for the static route.
Route".
Chapter 5
Setup and Configuration
543