Siemens RX1500 User Manual page 831

RUGGEDCOM ROX II
User Guide
Figure 920: Prefix Form
1. Off Link Check Box
6. On the Lifetime form, configure the following parameter(s) as required:
Parameter
Valid Lifetime
Preferred Lifetime
7. On the Prefix form, configure the following parameter(s) as required:
Parameter
Off Link
No Autoconfig
Set Router Address Flag
8. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
9. Click Exit Transaction or continue making changes.
Adding an IPv6 Network Prefix
1
2
3
2. No Autoconfig Check Box
Description
Synopsis: infinite
The length of time in seconds during which time the prefix is valid for the purpose of on-
link determination.
Prerequisite: The valid lifetime cannot be configured unless the preferred lifetime is
configured.
Synopsis: infinite
The length of time in seconds during which addresses generated from the prefix remain
preferred.
Prerequisite: The preferred lifetime cannot be configured unless the valid lifetime is
configured.
Description
Indicates that advertisement makes no statement about on-link or off-link properties of
the prefix.
Indicates to hosts on the local link that the specified prefix cannot be used for IPv6
autoconfiguration.
Indicates to hosts on the local link that the specified prefix contains a complete IP
address by setting the R flag.
Prerequisite: The router address can not be set unless off-link or no-autoconfig are
set.
3. Set Router Address Flag Check Box
Chapter 5
Setup and Configuration
799