Managing Priority To Cos Maps; Viewing A List Of Priorities; Adding A Priority - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Section 5.32.2

Managing Priority to CoS Maps

Assigning CoS to different IEEE 802.1p priority values in the frame is done by defining priority-to-CoS mapping
table entries.
The following sections describe how to configure and manage priority-to-CoS mapping:
• Section 5.32.2.1, "Viewing a List of Priorities"
• Section 5.32.2.2, "Adding a Priority"
• Section 5.32.2.3, "Deleting a Priority"
Section 5.32.2.1

Viewing a List of Priorities

To view a list of priorites, navigate to switch » class-of-service » priority-to-cos. If priorities have been
configured, the Priority to CoS Mapping table appears.
Figure 799: Priority to CoS Mapping Table
If no priorities have been configured, add priorities as needed. For more information, refer to
"Adding a Priority".
Section 5.32.2.2

Adding a Priority

To add a priority, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to switch » class-of-service » priority-to-cos and click <Add priority-to-cos>. The Key Settings
form appears.
682
RUGGEDCOM ROX II
User Guide
Section 5.32.2.2,
Managing Priority to CoS Maps