Chapter 5
Setup and Configuration
4.
Configure the following parameter(s) as required:
Parameter
host-ip
5.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6.
Click Exit Transaction or continue making changes.
Section 5.27.5.3
Deleting a Link Failover Ping target
To delete a link failover ping target, do the following:
1.
Change the mode to Edit Private or Edit Exclusive.
Navigate to services » link-failover » {interface} » target, where {interface} is the name of the interface.
2.
The Targets IP Addresses table appears.
1
Figure 713: Targets IP Addresses Table
1. Add Button
2. Edit Button
3.
Click Delete next to the chosen ping target.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
4.
to proceed.
Click Exit Transaction or continue making changes.
5.
Section 5.27.6
Testing Link Failover
The link failover settings can be tested to confirm that each link failover configuration works properly. To launch
the test, specify for how long the system should operate on the backup interface, and for how long the system
should delay before starting the test. Cancelling the test returns the interfaces to their pre-test condition.
While the test is running, monitor the status of the test to observe the main and backup link status, ping test
results, state change, backup state, and backup interface information. As the test progresses, this information
changes as link failover switches from the main interface to the backup interface. For more information on the
Link Fail Over Status form, refer to
610
Description
The IP address of the target host to verify the main path.
2
3
3. Delete Button
Section 5.27.2, "Viewing the Link Failover
RUGGEDCOM ROX II
Status".
Deleting a Link Failover Ping target
User Guide