Managing Interfaces; Viewing A List Of Interfaces - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
1
Figure 456: Area Tag Table
1. Add Button
3. Click Delete next to the chosen area tag.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.18.5

Managing Interfaces

IS-IS transmits hello packets and Link-State Packets (LSPs) through IS-IS enabled interfaces.
NOTE
IS-IS is only supported on Ethernet and WAN (HDLC-ETH) interfaces.
The following sections describe how to configure and manage interfaces for IS-IS:
• Section 5.18.5.1, "Viewing a List of Interfaces"
• Section 5.18.5.2, "Configuring an Interface"
Section 5.18.5.1

Viewing a List of Interfaces

To view a list of interfaces for dynamic IS-IS routes, navigate to routing » dynamic » isis » interface. If
interfaces have been configured, the Interface Parameters table appears.
Figure 457: Interface Parameters Table
Managing Interfaces
2. Edit Button 3. Delete Button
Chapter 5
Setup and Configuration
2
3
417