Stopping/Declining A Software Upgrade; Downgrading The Rox Ii Software - Siemens RX1500 User Manual

Chapter 3
Device Management
Parameter
Phase 2: Package Download (%
complete)
Phase 3: Package Installation (%
complete)
Last Attempt
Last Result
6. If the software upgrade is successful, reboot the device or decline the software upgrade. For more
information about rebooting the device, refer to
Section 3.11.4

Stopping/Declining a Software Upgrade

To stop/decline a recent software upgrade and revert back to the previously installed version, do the following:
IMPORTANT!
A software upgrade can only be declined before the device is rebooted. If the software upgrade has
already been activated following a reboot, the previous software version installed on the other partition
can be activated. For more information, refer to
Navigate to admin » software-upgrade and click decline-upgrade in the menu. The Trigger Action form
1.
appears.
Figure 56: Trigger Action Form
1. Perform Button
Click Perform.
2.
Section 3.11.5

Downgrading the ROX II Software

The ROX II software can be downgraded to a previous release at any time.
The following sections describe the various methods for downgrading the ROX II software:
64
Description
Phase 2 of the upgrade downloads all packages that require an update. This reflects the
estimated percentage complete.
Phase 3 of the upgrade installs all packages that require an update. This reflects the
estimated percentage complete.
The date and time of the completion of the last upgrade attempt.
Synopsis: Upgrade Successful, Upgrade Failed, Unknown, Reboot Pending, Not
Applicable, Declined, Interrupted
Indicates whether or not the last upgrade was completed successfully
Section 3.5, "Rebooting the
Section 3.11.5.1, "Rolling Back a Software
RUGGEDCOM ROX II
Device".
Upgrade".
1
Stopping/Declining a Software Upgrade
User Guide