Managing Traffic Control Priorities; Viewing A List Of Traffic Control Priorities - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
1
Figure 874: Basic Traffic Control Interfaces Table
1. Add Button
3. Click Delete next to the chosen traffic control interface.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.37.3

Managing Traffic Control Priorities

Traffic control priorities define priorities used for traffic shaping.
NOTE
Traffic control priorities can only be configured in basic mode. For more information about setting the
traffic control mode, refer to
The following sections describe how to configure and manage traffic control priorities:
• Section 5.37.3.1, "Viewing a List of Traffic Control Priorities"
• Section 5.37.3.2, "Adding a Traffic Control Priority"
• Section 5.37.3.3, "Deleting a Traffic Control Priority"
Section 5.37.3.1

Viewing a List of Traffic Control Priorities

To view a list of traffic control priorities, navigate to qos » traffic-control » basic-configuration » tcpriorities. If
priorities have been configured, the Basic Traffic Control Priorities table appears.
Figure 875: Basic Traffic Control Priorities Table
Managing Traffic Control Priorities
2. Edit Button 3. Delete Button
Section 5.37.1, "Enabling and Configuring Traffic
Chapter 5
Setup and Configuration
Control".
761
2
3