RUGGEDCOM ROX II
User Guide
Section 5.16.2.1
Viewing a List of Egress Source Ports
To view a list of egress source ports for port mirroring, navigate to switch » port-mirroring » egress-src. If
source ports have been configured, the Egress Source Ports table appears.
Figure 397: Egress Source Ports Table
If no egress source ports have been configured, add egress source ports as needed. For more information, refer
to
Section 5.16.2.2, "Adding an Egress Source
Section 5.16.2.2
Adding an Egress Source Port
To add an egress source port for port mirroring, do the following:
1.
Change the mode to Edit Private or Edit Exclusive.
2.
Navigate to switch » port-mirroring » egress-src and click <Add egress-src>. The Key Settings form
appears.
Figure 398: Key Settings Form
1. Egress Source Slot List
3.
Configure the following parameter(s) as required:
Parameter
Egress Source Slot
Egress Source Port
Click Add to create the new egress source port.
4.
Viewing a List of Egress Source Ports
Port".
1
2. Add Button
Description
Synopsis: sm, lm1, lm2, lm3, lm4, lm5, lm6
The name of the module location provided on the silkscreen across the top of the
device.
The selected ports on the module installed in the indicated slot.
Chapter 5
Setup and Configuration
2
363