Configuring Ntp Broadcast Clients - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Figure 292: NTP Multicast Clients Form
1. Enable Mutlicast Client Check Box
3. Configure the following parameter(s) as required:
Parameter
Enable Multicast Client
Address
4. Add a multicast address for a known NTP server. For more information, refer to
Broadcast/Multicast
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.12.6

Configuring NTP Broadcast Clients

The NTP broadcast client enables the NTP server to receive advertisements from other NTP servers and send
advertisements of its own.
To configure the NTP broadcast client, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to services » time » ntp. The Network Time Protocol (NTP) form appears.
Configuring NTP Broadcast Clients
1
2
2. Address Box
Description
Enables the multicast message mode.
Synopsis: The host type represents either an IP address or a DNS domain name.
Default: 224.0.1.1
The multicast address on which the NTP client listens for NTP messages.
Address".
Chapter 5
Setup and Configuration
Section 5.12.12.2, "Adding a
283