Siemens RX1500 User Manual page 128

Chapter 3
Device Management
Parameter
Inspect ToS
8. On the VLAN form, configure the following parameter(s) as required:
Parameter
PVID
Type
Format
GVRP Mode
NOTE
Once a VLAN ID has been assigned to a switched Ethernet port, a VLAN is created and can be
configured in switch » vlans » all-vlans.
9. If the port is in switchport mode, configure the VLAN for the port. For more information, refer to
Section 5.35.2, "Configuring VLANs for Switch Ethernet
10. Configure the port security settings. For more information, refer to
Security".
11. Configure the spanning tree settings. For more information, refer to
Switched Ethernet
12. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
13. Click Exit Transaction or continue making changes.
96
Description
The priority of frames received on this port that are not prioritized based on the frame's
contents (e.g. the priority field in the VLAN tag, DiffServ field in the IP header, prioritized
MAC address).
Enables or disables parsing of the Type-of-Service (ToS) field in the IP header of the
received frames to determine what Class of Service (CoS) they should be assigned.
When ToS parsing is enabled the switch will use the differentiated services bits in the
TOS field.
Description
The Port VLAN Identifier specifies the VLAN ID associated with untagged (and 802.1p
priority tagged) frames received on this port. Frames tagged with a non-zero VLAN ID
will always be associated with the VLAN ID retrieved from the frame tag.
Synopsis: edge, trunk, pvlanedge
Default: edge
How the port determines its membership in VLANs. There are a few types of ports:
• EDGE : the port is only a member of one VLAN (its native VLAN specified by the
'PVID' parameter).
• PVLAN Edge : the port does not forward traffic to other PVLAN edge ports within the
same VLAN.
• TRUNK : the port is automatically a member of all configured VLANs. Frames
transmitted out of the port on all VLANs except the port's native VLAN will be always
tagged. It can also be configured to use GVRP for automatic VLAN configuration.
Synopsis: untagged, tagged
Default: untagged
Whether frames transmitted out of the port on its native VLAN (specified by the 'PVID'
parameter) will be tagged or untagged.
Synopsis: advertise_only, learn_advertise
GVRP (Generic VLAN Registration Protocol) operation on the port. There are several
GVRP operation modes:
• DISABLED : the port is not capable of any GVRP processing.
• ADVERTISE ONLY : the port will declare all VLANs existing in the switch (configured
or learned) but will not learn any VLANs.
• ADVERTISE and LEARN : the port will declare all VLANs existing in the switch
(configured or learned) and can dynamically learn VLANs.
Ports".
Ports".
Section 3.18.3, "Configuring Port
Section 5.34.6, "Configuring STP for
Configuring a Switched Ethernet Port
RUGGEDCOM ROX II
User Guide