Deleting A Gsm Profile - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
sim
6. On the GSM PPP Configuration form, configure the following parameter(s) as required:
Parameter
use-peer-dns
username
password
dial-on-demand
disconnect-idle-timeout
failover-on-demand
mtu
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 5.13.2.3

Deleting a GSM Profile

To delete a GSM Profile, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to global » cellular » profiles » gsm. The Cellular Network Configuration table appears.
306
Description
The dial string given by the wireless provider to connect to the access point name.
Default: 1
Specify SIM index to be used by this profile
Description
Enables the DNS server entries that the PPP server recommends. Enables this option
unless you provide your own name servers.
Default: N/A
The user ID to connect to the remote server.
Default: N/A
The password to be authenticated by the remote server.
Activates dial-on-demand for this connection. The establishment of the PPP connection
is postponed until there is data to be transmitted via the interface. If dial-on-demand is
configured, Failover on Demand cannot be configured.
Prerequisite: If dial-on-demand is configured, Failover on Demand cannot be
configured.
Default: 0
The time in seconds to wait before disconnecting PPP when there is no traffic on the
link. This option is only valid when dial-on-demand is enabled.
Activates link failover on-demand on this device. PPP link establishment on this device
is controlled by link failover. If Failover on Demand is configured, Dial on Demand
cannot be configured.
Prerequisite: If link failover on-demand is configured, Dial on Demand cannot be
configured.
Default: 1500
MTU (Maximum Transmission Unit) value on a PPP interface.
RUGGEDCOM ROX II
User Guide
Deleting a GSM Profile