Managing Traffic Control Interfaces; Viewing A List Of Traffic Control Interfaces; Adding A Traffic Control Interface - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
. Add traffic control rules. For more information, refer to
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
Section 5.37.2

Managing Traffic Control Interfaces

Traffic control interfaces define interfaces used for traffic shaping, mainly for outbound bandwith and the outgoing
device.
NOTE
Traffic control interfaces can only be configured in basic mode. For more information about setting the
traffic control mode, refer to
The following sections describe how to configure and manage traffic control interfaces:
• Section 5.37.2.1, "Viewing a List of Traffic Control Interfaces"
• Section 5.37.2.2, "Adding a Traffic Control Interface"
• Section 5.37.2.3, "Deleting a Traffic Control Interface"
Section 5.37.2.1

Viewing a List of Traffic Control Interfaces

To view a list of traffic control interfaces, navigate to qos » traffic-control » basic-configuration » tcinterfaces.
If interfaces have been configured, the Basic Traffic Control Interfaces table appears.
Figure 871: Basic Traffic Control Interfaces Table
If no interfaces have been configured, add interfaces as needed. For more information, refer to
"Adding a Traffic Control
Section 5.37.2.2

Adding a Traffic Control Interface

To add a new traffic control interface, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
758
Section 5.37.1, "Enabling and Configuring Traffic
Interface".
Section 5.37.6.2, "Adding a Traffic Control
Managing Traffic Control Interfaces
RUGGEDCOM ROX II
User Guide
Rule".
Control".
Section 5.37.2.2,