Adding An Egress Port; Deleting An Egress Port - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
If no egress ports have been configured, add egress ports as needed. For more information, refer to
Section 5.25.6.2, "Adding an Egress
Section 5.25.6.2

Adding an Egress Port

To add an egress port to a static multicast group defined in the Static Multicast Group Summary table, do the
following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to switch » mcast-filtering » static-mcast-table » {id/address} » egress-ports, where {id/
address} is the VLAN ID for the static multicast group and the MAC address for the host device.
Click <Add egress-ports>. The Key Settings form appears.
3.
Figure 670: Key Settings Form
1. Slot List 2. Add Button
4. Configure the following parameter(s) as required:
Parameter
Slot
Port
5. Click Add to create the egress port.
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
Section 5.25.6.3

Deleting an Egress Port

To delete an egress port for a static multicast group defined in the Static Multicast Group Summary table, do the
following:
Change the mode to Edit Private or Edit Exclusive.
1.
Adding an Egress Port
Port".
1
Description
Synopsis: sm, lm1, lm2, lm3, lm4, lm5, lm6
The name of the module location provided on the silkscreen across the top of the
device.
The selected ports on the module installed in the indicated slot.
Chapter 5
Setup and Configuration
2
577