RUGGEDCOM ROX II
User Guide
2.
Navigate to routing » static » ipv4 » {subnet} » via, where subnet is the subnet (network/prefix) of the
static route. The Static Route Using Gateway table appears.
1
Figure 633: Static Route Using Gateway Table
1. Add Button
3.
Click Delete next to the chosen gateway address.
4.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5.
Click Exit Transaction or continue making changes.
Section 5.22.7
Managing Interfaces for Static Routes
The following sections describe how to configure and manage interfaces for static routes:
•
Section 5.22.7.1, "Configuring Interfaces for IPv6 Static Routes"
•
Section 5.22.7.2, "Viewing a List of Interfaces for IPv4 Static Routes"
•
Section 5.22.7.3, "Adding an Interface for an IPv4 Static Route"
•
Section 5.22.7.4, "Deleting an Interface for an IPv4 Static Route"
Section 5.22.7.1
Configuring Interfaces for IPv6 Static Routes
To configure an interface for an IPv6 static route, do the following:
1.
Change the mode to Edit Private or Edit Exclusive.
Navigate to routing » static » ipv6 » {subnet}, where subnet is the subnet (network/prefix) of the static
2.
route.
Click the + symbol in the menu next to dev. The Static Route Using Interface form appears
3.
Managing Interfaces for Static Routes
2. Edit Button
3. Delete Button
2
3
Chapter 5
Setup and Configuration
545