Viewing Qos Statistics - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Section 5.37.9

Viewing QoS Statistics

ROX II provides statistics for traffic going through each class that has been configured. Packets are assigned to
classes on the outbound interface based on rules. If a packet matches the specified criteria, it is considered to be
a member of the class and is forwarded to that class. If the packet does not match any rule, it is forwarded to the
default class.
For more information about traffic control classes, refer to
NOTE
Statistics are only available when traffic control is enabled in advanced mode. For more information
about enabling traffic control, refer to
To view the QoS statistics, navigate to qos » statistics. The QoS Statistics table appears.
1
Figure 905: QoS Statistics Table
1. Class Name 2. Minimum Configured Bandwidth
6. Packages Dropped
This table provides the following information:
Parameter
Class Name
Minimum Configured Bandwidth
Maximum Configured Bandwidth
Bytes Sent
Packets Sent
Packets Dropped
10-Second Average
10-Second Average: Packets per Second
Viewing QoS Statistics
2 3
7. 10-Second Average 8. 10-Second Average per Second
Description
The minimum guaranteed bandwidth. This is based on the device's defined characteristics.
The maximum guaranteed bandwidth in absence of any higher prioritized traffic. This is
based on the device's defined characteristics.
The number of bytes that were sent through this class.
The number of packets that were sent through this class.
The number of packets that were dropped in this class.
Based on a 10-second average.
Based on a 10-second average.
Section 5.37.4, "Managing Traffic Control
Section 5.37.1, "Enabling and Configuring Traffic
4 5
3. Maximum Configured Bandwidth
Setup and Configuration
6 7
4. Bytes Sent 5. Packages Sent
Chapter 5
Classes".
Control".
8
787