Viewing A List Of Ip Addresses; Adding An Ip Address - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Section 5.29.8.1

Viewing a List of IP Addresses

To view a list of remote L2 protocol server IP addresses for a generic tunnel configuration, navigate to tunnel »
l2tunneld » generic » {name} » remote-daemon » ip-address, where {name} is the name of the generic tunnel.
If IP addresses have been configured, the Remote Daemon IP Address table appears.
Figure 773: Remote Daemon IP Address Table
If no generic tunnels have been configured, add tunnels as needed. For more information, refer to
Section 5.29.7.3, "Adding a Generic
Section 5.29.8.2

Adding an IP Address

To add the IP address of a remote L2 protocols server to a generic tunnel configuration, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to tunnel » l2tunneld » generic » {name} » remote-daemon » ip-address, where {name} is the
name of the generic tunnel.
3. Click <Add ip-address>. The Key Settings form appears.
Figure 774: Key Settings Form
1. IP Address Box
4. Configure the following parameter(s) as required:
Parameter
ip-address
5. Click Add to add the IP address.
Viewing a List of IP Addresses
Tunnel".
1
2. Add Button
Description
The IP address of the remote L2 protocol server.
Chapter 5
Setup and Configuration
2
657