Deleting A Static Label - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
5. Click Add to apply the static label to the destination address. The Static MPLS Bindings for IPv4
Addresses or Static MPLS Bindings for IPv6 Addresses form appears.
Figure 932: Static MPLS Bindings for IPv4 Addresses Form (Example)
1. In Label Box
6. Configure the following parameter(s) as required:
Parameter
In Label
Next Hop
Out Label
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 5.39.5.4

Deleting a Static Label

To delete a static label, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to mpls » static-mpls » binding » {protocol}, where {protocol} is either ipv4 or ipv6. The Static
MPLS Bindings for IPv4 Addresses or Static MPLS Bindings for IPv6 Addresses table appears.
808
Description
Prerequisite: LDP must be disabled before declaring MPLS label bindings.
1
2
3
2. Next Hop Box 3. Out Label Box
Description
The incoming label: integer 16 -> 1048575.
The IP address for the destination next-hop router.
Prerequisite: The destination out-label must also be defined.
Synopsis: explicit-null, implicit-null,
The outgoing label: 'explicit-null', 'implicit-null' or integer 16 -> 1048575.
Prerequisite: The destination next-hop must also be defined.
RUGGEDCOM ROX II
User Guide
Deleting a Static Label