Viewing Netconf Statistics - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Parameter
enabled
Listen IP
Listen Port
Extra IP:Ports
Maximum Number of NETCONF Sessions
Idle Timeout
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.10.2

Viewing NETCONF Statistics

To view NETCONF related statistics, navigate to admin » netconf. The NETCONF State/Statistics form
appears.
Viewing NETCONF Statistics
Description
Default: true
Provides the ability to configure NETCONF features on the device.
Synopsis: The ip-address type represents an IP address and is IP version neutral.
The format of the textual representations implies the IP version.
Default: 0.0.0.0
The IP Address the CLI will listen on for NETCONF requests.
Synopsis: The port-number type represents a 16-bit port number of an Internet
transport layer protocol such as UDP, TCP, DCCP, or SCTP. Port numbers are assigned
by IANA. A current list of all assignments is available from <http://www.iana.org/>. Note
that the port number value zero is reserved by IANA. In situations where the value
zero does not make sense, it can be excluded by subtyping the port-number type. In
the value set and its semantics, this type is equivalent to the InetPortNumber textual
convention of the SMIv2.
Default: 830
The port on which NETCONF listens for NETCONF requests.
Synopsis: "extra-ip-ports" occurs in an unbounded array
Additional IP addresses and ports on which NETCONF listens for NETCONF requests.
You can specify IP addresses and ports in the following forms:
• nnn.nnn.nnn.nnn:port represents an IPv4 address followed by a colon and port
number. For example, 192.168.10.12:19343
• 0.0.0.0 represents the default IPv4 address and default port number. This is the
default configuration.
• [::]:port represents an IPv6 address followed by a colon and port number. For
example, [fe80::5eff:35ff]:16000
• If using the default address, do not specify another listen address with the same port.
Synopsis: unbounded
Default: 10
The maximum number of concurrent NETCONF sessions.
Default: PT0S
The maximum idle time before terminating a NETCONF session. If the session is waiting
for notifications, or has a pending confirmed commit, the idle timeout is not used. A
value of 0 means no timeout.
Chapter 5
Setup and Configuration
253