Viewing A List Of Areas; Adding An Area - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Section 5.21.5.1

Viewing a List of Areas

To view a list of areas configured for dynamic OSPF routes, navigate to routing » dynamic » ospf » area. If
areas have been configured, the OSPF Area table appears.
Figure 594: OSPF Area Table
If no areas have been configured, add areas as needed. For more information, refer to
an Area".
Section 5.21.5.2

Adding an Area

To add an area for dynamic OSPF routes, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to routing » dynamic » ospf » area and click <Add area>. The Key Settings form appears.
2.
Figure 595: Key Settings Form
1. Area ID Box
3. Configure the following parameter(s) as required:
Parameter
Area ID
Area Network/Prefix
Click Add to create the new area. The OSPF Area form appears.
4.
518
1
2
2. Area Network/Prefix Box 3. Add Button
Description
The OSPF Area ID (format: A.B.C.D).
The OSPF area network/prefix.
RUGGEDCOM ROX II
User Guide
Section 5.21.5.2, "Adding
3
Viewing a List of Areas