Configuring The Device - Siemens SIMATIC NET RUGGEDCOM RS900G Equipment Manual

Device Management
3.2 Configuring the Device
The following is the pin-out for the port:
Figure 3.1
a
Connected internally.
b
Connected internally.
Communication Ports
Connect any of the available Ethernet ports on the device to a management
switch and access the RUGGEDCOM RS900G console and Web interfaces via the
device's IP address. The factory default IP address for the RUGGEDCOM RS900G is
https://192.168.0.1.
For more information about available ports, refer to "Communication
Ports" (Page 17).
3.2

Configuring the Device

Once the device is installed and connected to the network, it must be configured. All
configuration management is done via the RUGGEDCOM RS900G interface. For more
information about configuring the device, refer to the "RUGGEDCOM RS900G User
Guide" associated with the installed software release.
16
5 1
9 6
Serial DB9 Console Port
Pin Name
a
1 Reserved (Do Not Connect)
2 TX
3 RX
a
4 Reserved (Do Not Connect)
5 GND
a
6 Reserved (Do Not Connect)
b
7 Reserved (Do Not Connect)
b
8 Reserved (Do Not Connect)
9 Reserved (Do Not Connect)
Equipment Manual, 10/2023, C79000-G8976-1025-10
Description
Transmit Data
Receive Data
Signal Ground
RUGGEDCOM RS900G