Managing Link Failover Parameters - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 702: Link Fail Over Status Form
1. Main Link Status 2. Backup Link Status
Interface in Use
This form provides the following information:
Parameter
main-link-status
backup-link-status
main-ping-test
time-of-last-state-change
link-backup-state
backup-interface-in-use
Section 5.27.3

Managing Link Failover Parameters

The following sections describe how to configure and manage parameters for link failover protection:
• Section 5.27.3.1, "Viewing a List of Link Failover Parameters"
• Section 5.27.3.2, "Adding a Link Failover Parameter"
• Section 5.27.3.3, "Deleting a Link Failover Parameter"
602
1
2
3
4
5
6
3. Main Ping Test
Description
The main link status.
The backup link status.
The results of pinging the target using the main interface.
The time of the last state change.
The backup link state.
The name of the backup interface that is being used.
4. Time of Last State Change
RUGGEDCOM ROX II
User Guide
5. Link Backup State 6. Backup
Managing Link Failover Parameters