Viewing A List Of Mpls Interfaces; Enabling/Disabling An Mpls Interface - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Parameter
MPLS Interfaces
Status
If no MPLS interface has been enabled, enable interfaces as needed. For more information about enabling MPLS
interfaces, refer to Section 5.39.4.3, "Enabling/Disabling an MPLS
Section 5.39.4.2

Viewing a List of MPLS Interfaces

To view a list of MPLS interfaces, navigate to mpls » interface-mpls. If MPLS interfaces have been configured,
the MPLS Interface List Configuration table appears.
Figure 927: MPLS Interface List Configuration Table
If no MPLS interfaces have been configured, enable interfaces as needed. For more information about enabling
MPLS interfaces, refer to
Section 5.39.4.3

Enabling/Disabling an MPLS Interface

To enable or disable an MPLS interface, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to mpls » interface-mpls » interface where interface is the name of the interface to enable or
disable for MPLS. The MPLS Interface List Configuration form appears.
Figure 928: MPLS Interface List Configuration Form
1. Enable Check Box
3. Configure the following parameter(s) as required:
Viewing a List of MPLS Interfaces
Description
The interface that has been enabled for MPLS.
The operational status.
Section 5.39.4.3, "Enabling/Disabling an MPLS
1
Interface".
Interface".
Chapter 5
Setup and Configuration
805