Configuration And License Plug (Clp) - Siemens SIMATIC NET RUGGEDCOM RST2228P Equipment Manual

—
During operation
Red
—
Power supply LEDs
The PS1 and PS2 LEDs indicate status of the corresponding power supply.
These LEDs only illuminate during operation, not during startup.
The meaning of each LED is as follows:
LED color
—
Green
PoE LED
The PoE LED indicates the status of the Power-over-Ethernet (PoE) power source.
Green
—
ACO button
The Alarm Cut-Off (ACO) button clears alarms and turns off the A LED.
1.2.4

Configuration and License PLUG (CLP)

The Configuration and License PLUG (CLP) is a removable USB storage medium for
backing up and exchanging data, such as configuration files, system firmware, and
product licenses.
The CLP has a USB type C interface and can be used with the following devices that
have a corresponding interface:
•
•
Position
The CLP slot is located below the status panel.
RUGGEDCOM RST2228P
Equipment Manual, 10/2023, C79000-G8976-1403-17
LED color LED state
Off
LED color LED state
On
Off
State
Off
On
LED color LED state
On
Off
Siemens products
Personal computers (PCs), such as desktop PCs, tablet PCs, laptops, or
smartphones
1.2.4 Configuration and License PLUG (CLP)
Device startup was completed successfully.
One or more active alarms.
No active alarms.
No external power supply connected.
An external power supply is connected and powered.
The device is receiving power.
The device is not receiving sufficient power.
Introduction
Description
Description
Description
Description
9