Ipv6 Nd Accept-Ra-Default-Routes - Allied Telesis IE220 Series Manual

IP 6 C
V OMMANDS
6 - - -
IPV ND ACCEPT RA DEFAULT ROUTES

ipv6 nd accept-ra-default-routes

Overview Use this command to allow accepting and installing of default routes based on a
received RA (Router Advertisement). The default route's destination is set to the
source address of the received RA.
Use the no variant of this command to disable accepting RA-based default routes.
Syntax ipv6 nd accept-ra-default-routes
no ipv6 nd accept-ra-default-routes
Default RA-based default routes are accepted by default.
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Example To enable RA-based default routes on vlan1, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 address
commands
ipv6 address autoconfig
ipv6 enable
C613-50644-01 Rev B
configure terminal
interface vlan1
ipv6 enable
no ipv6 nd accept-ra-pinfo
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
909