Interfaces; Basic Interface Commands; Clear Counters - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

Interfaces

The commands in this chapter are supported by Dell Networking operating software on the S4810

This chapter contains the following sections:

Port Channel Commands

Time Domain Reflectometer (TDR)

UDP Broadcast

Basic Interface Commands

The following commands are for Physical, Loopback, and Null interfaces.

Clear the counters used in the show interfaces commands for all virtual router redundancy protocol

(VRRP) groups, virtual local area networks (VLANs), and physical interfaces, or selected ones.

clear counters [interface] [vrrp [ipv6 {vrid} | learning-limit]

(OPTIONAL) Enter any of the following keywords and slot/

port or number to clear counters from a specified interface:

For IPv4 access-group counters, enter the keyword ip.

For IPv6 access-group counters, enter the keyword ipv6.

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For MAC access-group counters, enter the keyword mac.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For the management interface on the RPM, enter the

keyword ManagementEthernet then slot/port

information. The slot range is from 0 to 1 and the port

For a 10-Gigabit Ethernet interface, enter the keyword

tenGigE then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

Show Quick Links

Table of Contents