Bgp Neighbor Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
BGP N
EIGHBOR
To activate the BGP Neighbor Configuration mode, enter the bgp-neighbor command at the Global
Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#router bgp 65000
ProCurve(config-bgp)#neighbor 65.4.3.192
ProCurve(config-bgp-neighbor)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
advertisement-interval <seconds>
as-path-list <listname> [in | out]
ebgp-multihop <hop count>
hold-timer <hold time>
local-as <as-number>
next-hop-self on page 1319
password <password>
prefix-list <listname> [in | out]
remote-as <as-number>
route-map <map-name> [in | out]
send-community standard
soft-reconfiguration inbound
update-source <interface>
5991-2114
C
ONFIGURATION
on page 1434
on page 1314
on page 1315
on page 1316
on page 1317
on page 1318
on page 1320
on page 1321
on page 1322
on page 1323
on page 1324
on page 1325
on page 1326
© Copyright 2006 Hewlett-Packard Development Company, L.P.

BGP Neighbor Configuration Command Set

C S
OMMAND ET
on page 1431
1313