HP ProCurve 7102dl Reference Manual page 1313

SROS Command Line Interface Reference Guide BGP Configuration Command Set
neighbor <address>
Use the neighbor command to create a BGP neighbor, specify an IP address, and activate the BGP
neighbor configuration commands. Refer to BGP Neighbor Configuration Command Set on page 1313 for
more information on neighbor-specific configuration parameters. Use the no form of this command to
remove the configured neighbor.
Syntax Description
<address> Specifies the IP address for the neighbor in dotted decimal notation.
Default Values
By default, there are no configured BGP neighbors.
Usage Examples
The following example configures a BGP neighbor with an IP address of 172.20.2.50:
ProCurve(config)#router bgp 65000
ProCurve(config-bgp)#neighbor 172.20.2.50
ProCurve(config-bgp-neighbor)#
5991-2114 © Copyright 2006 Hewlett-Packard Development Company, L.P. 1311