SROS Command Line Interface Reference Guide
match tag <value>
Use the match tag command to configure the route map to filter traffic based on a route's tag value. Use
the no form of this command to discontinue matching.
Syntax Description
<value>
Default Values
No default value is necessary for this command.
Functional Notes
More than one value may be specified as a tag to be matched.
The ip route command is related to the match tag command in that it includes an optional parameter to
set the route tag value for local static routes.
VPN RRI (Reverse-Route Injection) routes can also have a tag applied.
Usage Examples
The following example instructs the route map named MyMap to match a route tag of 100 or 200:
ProCurve(config)#route-map MyMap permit 1
ProCurve(config-route-map)#match tag 100 200
5991-2114
Specifies the desired route tag value to match. If more than one value is
specified, the match command will pass if any value matches. Valid range is
1 to 65,535.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Route Map Command Set
1287