Satellite Client Port Association; Software Repositories; Administrative Tasks; Configuring The Chassis Mode - Alcatel-Lucent 7450 Basic System Configuration Manual

Satellite Client Port Association

Use the following format to reference Ethernet satellite client ports:
port esat- sat-id/1/sat-port

Software Repositories

The software repositories define the locations from where the host can obtain software for
subcomponents including Ethernet satellites. The software repository is also used to upgrade
an existing subcomponent by changing the location of the image to be served to the remote
device. The software repositories are not used for management of the host router software,
which is managed using the standard procedures described in the Release Notes.
Each software repository supports up to three locations to search for the software. A location
may be a URL or a directory on a compact flash. When an upgrade operation is initiated, each
of the three locations is checked in sequence to locate the required software. The upgrade
operation will fail if the software is not located in any of the configured locations. The
satellite booting operation will also fail if the software cannot be located.

Administrative Tasks

This section contains information to perform administrative tasks.

Configuring the Chassis Mode

Depending on the 7450 ESS and 7750 SR chassis type and IOM type, the following modes
can be configured:
Basic System Configuration Guide
• Configuring the Chassis Mode
• Saving Configurations
• Specifying Post-Boot Configuration Files
• Network Timing
• Power Supplies
System Management
281