Ip Load Rip - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

ip load rip

Loads RIP into memory. When the switch is initially configured, you must load RIP into memory before it
can be enabled.
ip load rip
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
In simple networks where only IP forwarding is required, you may not want to use RIP. If you are not
using RIP, it is best not to load it to save switch resources.
•
To remove RIP from switch memory, you must manually edit the boot.cfg file. The boot.cfg file is an
ASCII text-based file that controls many of the switch parameters. Open the file and delete all refer-
ences to RIP. You must reboot the switch when this is complete.
•
Use the ip rip status
Examples
-> ip load rip
Release History
Release 6.6.1; command was introduced.
Related Commands
ip rip status
show ip rip
MIB Objects
alaDrcTmConfig
alaDrcTmIPRipStatus
page 33-2
command to enable RIP on the switch.
Enables/disables RIP routing on the switch.
Displays the RIP status and general configuration parameters (e.g.,
forced hold-down timer).
OmniSwitch 6250 CLI Reference Guide
RIP Commands
November 2009