Getting Started
Connections and Cabling
Once your switch is properly installed, you should connect all network and management cables required for
your network applications. Connections may include:
Console connector
•
Cables to NIs or transceivers
•
Network Cable Installation Warning
Never install exposed network cables outdoors. Install network cables per manufacturer requirements.
Serial Connection to the Console Port
The console port provides a serial connection to the switch is required when logging into the switch for the
first time. By default, this connector provides a DCE console connection.
Serial Connection Default Settings
baud rate
parity
data bits (word size)
stop bits
For information on modifying these settings, refer to the OmniSwitch 6560 Switch
Management Guide.
OmniSwitch 6560 Hardware Users Guide
9600
none
8
1
December 2019
Connections and Cabling
page 2-5