Adding Circuit Packs; Install The Circuit Packs - Avaya S8700 Manual

Adding circuit packs

Adding circuit packs
When installing additional features or equipment, it may be necessary to install additional circuit packs.
This is a general procedure to use when adding features or equipment that require adding circuit packs.
1
Log into the media server using a services log in.
2
Install the TN circuit pack into the media gateway or carrier (if MCC1).
3
Do the minimally required administration so that Avaya Communication Manager recognizes the
circuit pack.
4
Log off the media server after the addition and any required administration is complete.
For information about further administering circuit packs and other equipment, refer to the
Administrator's Guide for the Avaya Communication Manager (555-245-207).

Install the Circuit Packs

1
Insert the circuit pack into any port slot. If the slot was assigned a slot location, then put it in the
assigned slot.
2
Type list configuration all and press
installed circuit pack(s).
The following tasks are covered in this section
•
Install and Administer IP Connectivity Hardware
•
Install and Administer Trunks and Lines
14
NOTE:
If a circuit pack requires a right-to-use fee for a particular feature, then the customer must
have a license file to enable the feature.
NOTE:
If an S8700 Media Server, you must log into the active media server to access SAT
commands. Use a terminal emulation application, such as Avaya Terminal Emulation, or
Avaya Site Administration.
CAUTION:
When adding or replacing any hardware and associated cables and adapters, be sure to
ground yourself against electrostatic discharge (ESD) by wearing a grounded wrist strap.
NOTE:
Circuit packs are hot-swappable, so you do not need to power down the carrier or media
gateway to install them.
NOTE:
To properly seat a circuit pack, push firmly on the front of the faceplate until the latch
reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.
Enter to verify that the system recognizes the newly
on page 15
on page 32
Adding New Hardware--S8700
November 2003