Honda ACCORD HYBRID 2005 Service Manual page 234

Cooling System
W a t e r P a s s a g e R e p l a c e m e n t ( c o n t ' d )
10. Remove the EGR valve (A), ECT sensor 1 (B), ECT
sensor 2 (C), thermostat cover (D), and thermostat
(E).
6 x 1.0 m m
12 N m
(1.2 k g f m , 8.7 Ibfft)
11. Install the new rubber seal (F) to the thermostat,
then install the t h e r m o s t a t w i t h pin (G) up, and
install the thermostat cover.
12. Install the ECT sensor 1 and ECT sensor 2, using the
new O-rings (H).
13. Install the EGR valve, using a n e w gasket (I).
14. Install the connecting pipe (A) and water passage
(B), using the new O-rings (C) and new gaskets (D).
15. Install the harness c l a m p bracket to the rear
cylinder head (see step 35 on page 5-16).
16. install the heater hoses.
10-10