Honda ACCORD HYBRID 2005 Service Manual page 248

Fuel and Emissions Systems
G e n e r a l T r o u b l e s h o o t i n g I n f o r m a t i o n
9. Install the PCM in the reverse order of removal.
10. Open t h e S C S w i t h the HDS.
11. Turn the ignition switch ON (II).
NOTE: DTC P0630 " V I N Not P r o g r a m m e d or
M i s m a t c h " will be stored at this t i m e because VIN
has not been p r o g r a m m e d into the PCM, but ignore
it and continue this procedure.
12. Input the VIN to the PCM w i t h the HDS.
13. Rewrite the immobilizer code w i t h the PCM
replacement procedure in the HDS; it allows you to
start the engine.
14. Reset the PCM w i t h the HDS.
(cont'd)
OBD Status
The OBD status shows the current system status of
each DTC and all of the parameters. This f u n c t i o n is
used to see if the technician's repair was successfully
finished. The results of diagnostic tests for the DTC are
displayed as:
• PASSED: On board diagnosis is successfully finished.
• FAILED: On board diagnosis has finished but failed.
• EXECUTING: The vehicle is in enable criteria
conditions for the DTC and the on board diagnosis is
running.
• NOT COMPLETED: The on board diagnosis w a s
running but is out of the enable conditions of the DTC.
• OUT OF CONDITION: The vehicle has stayed out of
the enable conditions of the DTC.
15. Do the PCM idle learn procedure (see page 11-340).
16. Do the CKP pattern learn procedure.
11-8