Honda ACCORD HYBRID 2005 Service Manual page 247

2. Connect the HDS or the Honda interface module
(HIM) to the data link connector (DLC) (A) located
under the driver's side of the dashboard.
3. Do the PCM update procedure as described on the
HIM label and in the PCM update system.
4. Check for DTCs w i t h the HDS. If DTC U0300 is
indicated, go to troubleshooting U0300, then back
to " P C M U p d a t i n g " . If DTC is not indicated, go to
step 5.
5. Do the PCM idle learn procedure (see page 11-340).
6. Do the CKP pattern clear/pattern learn procedure.
How to Substitute the PCM
1. Connect the HDS to the data link connector (DLC)
(A) located under the driver's side of the dashboard.
2. Turn the ignition switch ON (II).
3. Turn the ignition switch OFF.
4. J u m p the SCS line w i t h the HDS.
5. Remove the center lower cover (A).
6. Remove the duct (B).
7. Disconnect the PCM connectors (C).
8. Remove the bolts (D), then remove the PCM (E).
(cont'd)
11-7