Toyota T100 1996 Service Manual page 1890

Lock
1
BE2595 N02427
(c) Close
11
BE2886 N03190R
1996 TOYOTA T100 (RM449U)
BODY ELECTRICAL
(d)
(e)
6
If operation is not as specified, replace the relay.
Z14872
10.
(d) Open
HINT:
When the relay circuit is as specified, inspect the key−off power
window signal.
(a)
(b)
(c)
I02177
(d)
(e)
5
If operation is not as specified, replace the relay.
Z08642
− POWER DOOR LOCK CONTROL SYSTEM
Reverse the polarity of the voltmeter leads.
Set the door lock control switch to LOCK, check that the
voltage rises from 0 V to battery positive voltage for
approximately 0.2 seconds.
Key−off Power Window Signal:
INSPECT DOOR LOCK CONTROL RELAY
Connect the connector to the relay.
Connect the positive (+) lead from the voltmeter to termi-
nal 5 and the negative (−) lead to terminal 11.
Close the door with ignition switch turned to LOCK or
ACC, check that the meter needle indicates battery posi-
tive voltage.
Open the door, check that the meter needle indicates 0 V.
Turn the ignition switch ON, check that the meter needle
indicate battery positive voltage again.
BE−55