Toyota T100 1996 Service Manual page 1880

4WD Indicator Light
Ignition
Switch
Battery
(Wire Harness Side)
OFF
ON
Bright
Extinguished
Dark
1996 TOYOTA T100 (RM449U)
BODY ELECTRICAL
25. INSPECT INTEGRATION RELAY SEAT BELT WARN-
ING SYSTEM OPERATION
(a) Connect the positive (+) lead from the battery to terminals
3 and 9.
(b) Connect the terminal 8 to terminal 9 through the 3.4 W test
bulb.
(c) Connect the negative (−) lead from the battery to terminal
7.
(d) Check that the bulb lights and the buzzer sounds.
N12611
(e) Return to step (a), and operate the buzzer again.
(f) Connect the negative (−) lead from the battery to terminal
6.
(g) Check that the buzzer stops sounding.
HINT:
Check the buzzer within a period of 4 to 8 seconds.
If operation is not as specified, replace the relay.
26. INSPECT INTEGRATION RELAY CIRCUIT (See page
BE−12)
N12612
27. INSPECT 4WD INDICATOR LIGHT
(a) Disconnect the connector from the 4WD indicator switch.
Connect the switch terminal 2 and body ground.
(b) Turn the ignition switch on. Check that the bulb lights up.
If operation is not as specified, remove and test the bulb.
Z04393
28. INSPECT 4WD INDICATOR SWITCH
(a) Check that the there is continuity when the switch pin is
pushed.
(b) Check that there is no continuity when the switch is free.
If operation is not as specified, replace the switch.
BE3241
29. INSPECT LIGHT CONTROL RHEOSTAT
Test Bulb
(3.4W) (a) Connect terminals 1 and 3 through a 3.4 W test bulb.
(b) Connect the positive (+) lead from the battery to terminal
1 and the negative (−) lead to terminal 2.
(c) Turn the rheostat knob fully counterclockwise, check that
the test bulb goes out.
(d) Gradually turn the rheostat knob clockwise, check that
the test bulb brightness changes from dark to bright.
If operation is not as specified, replace the rheostat.
Z04394
− COMBINATION METER
BE−45