Toyota T100 1996 Service Manual page 1970

BO−50
15°
1996 TOYOTA T100 (RM449U)
BODY
INSPECTION
CAUTION:
Replace the seat belt assembly (outer belt, inner belt, bolts
or nuts and sill−bar) if it has been used in a severe impact.
The entire assembly should be replaced even if damage is
not obvious.
1. All seat belts:
RUNNING TEST (IN SAFE AREA)
(a) Fasten the seat belts.
(b) Drive the car at 10 mph (16 km/h) and make a very hard
stop.
(c) Check that the seat belt is locked and cannot be extended
at this time.
HINT:
Conduct this test in a safe area. If the belt does not lock, remove
the belt mechanism assembly and conduct the following static
check. Also, whenever installing a new belt assembly, verify the
proper operation before installation.
2. All seat belts:
BO0632
STATIC TEST
(a) Make sure that the belt locks when pulled out quickly.
(b) Remove the locking retractor assembly.
45°
(c) Tilt the retractor slowly.
(d) Make sure that the belt can be pulled out at a tilt of 15 de-
grees or less, and cannot be pulled out at over 45 degrees
of tilt.
If a problem is found, replace the assembly.
3. Except driver's seat belt:
STATIC TEST
BO0633
(a) Pull out the whole belt, release it slightly and then pull it
out again.
(b) Make sure that the belt cannot be extended further.
If a problem is found, replace the assembly.
4. Manual type seat belt:
TEST
(a) Adjust the belt to the proper length.
(b) Apply a firm load to the belt.
(c) Make sure that the belt does not extend.
N15359
− SEAT BELT
BO0FD−02